Denis LedererCanadian Waterproofing Systems · Victoria BC ☎ 250-889-5620

Roof repair · Leak tracing · Victoria BC

Roof repair in Victoria, BC — leak detection and repair.

A ceiling stain tells you where water ended up, not where it got in. I trace leaks back to the actual entry point — a split seam, a dead flashing, a vent boot that gave up — show you the photos, and repair that. If your roof is still leaking after a repair, this page is especially for you: that’s the call I get most.

Roof repair work by Denis Lederer in Victoria BC — the way a finished repair should look
Repair work the way it should look when it’s finished.

Still leaking after a repair? Here’s why.

It is the highest-frustration call in roofing: you paid for a repair, and the stain is back. Three repairs and it still leaks usually means three patches on the drip point and zero time spent finding the entry point. Water is patient — it gets in at a seam or flashing, runs along the top of the deck, a purlin or a vapour barrier, and shows up wherever gravity gives up. Sometimes that’s a different room from the leak.

My approach is leak forensics, not guesswork: read the stain pattern, get on the roof, check the suspects uphill of the stain in order — seams, flashings, penetrations, drains — and prove the entry point before touching a tool. You get photos of what I found and a written estimate for fixing that.

Why is my flat roof ponding water?

Flat roofs are supposed to drain. Water sitting 48 to 72 hours after the rain stops is ponding, and it is quietly eating your roof: extra weight on the structure, algae and dirt at every seam, and freeze-thaw working on the details all winter. Causes are usually a deck that has settled, insulation with no taper, or drains set too high. The fixes are drainage fixes — tapered insulation, crickets, re-set drains — not another layer of membrane over the puddle. If a quote for your ponding roof doesn’t mention slope, it isn’t fixing the problem.

Coastal leak signatures I see every winter

  • Leaks only when it rains and blows — wind-driven rain getting under flashings and laps that hold fine in a straight-down rain. The Island specialty.
  • Skylight leaking at the corners — usually the flashing kit or the curb detail, rarely the skylight itself.
  • Chimney flashing leaks — counter-flashing that was caulked instead of cut into the mortar joint.
  • Blocked drains and scuppers — the flat roof that “suddenly” leaks in November is often just drowning.
  • Ceiling stain but no drip — slow entry, spreading through insulation. It has usually been leaking longer than you think.

How I handle a leak

  • Diagnose first. I inspect the roof and the attic side if needed, and find where water actually enters — not just where it drips.
  • Photos and a written estimate. You see what I see, and the price is in writing before work starts.
  • Temporary dry-in when it’s pouring. If the weather is against us, I stop the water first and do the permanent repair when it’s safe.
  • A repair that matches the system. Welded TPO patches on TPO, proper torch-on details on SBS, new flashing metal bent to fit — not a bucket of tar smeared on everything.
  • Insurance documentation. Photos and a written report you can hand to your insurer.

Not sure if it’s a repair or a replacement? That’s a condition report question — an independent answer, in writing, before you commit to either.

Watch a TPO leak repair

CWS - TPO roof repair Victoria, BC — 1,114 views. How I identify and fix leaks on a TPO flat roof.

Frequently asked questions

Why is my roof still leaking after a repair?

Usually because the repair treated the stain, not the source. Water enters at a failed seam, flashing or penetration, travels along the deck or a beam, and drips somewhere else entirely — sometimes a room away. A patch over the drip point does nothing. Leak tracing means working back from the stain to the actual entry point, testing the suspects in order, and fixing that. It is the part of the trade Denis enjoys most, and the part most repair visits skip.

Why is my flat roof ponding water?

Because the roof has lost its slope to the drains — from insulation that was never tapered, a deck that has settled, or drains set too high. Water should clear within 48 to 72 hours after rain. Ponding adds weight, grows algae, works on every seam, and voids some warranties. Fixes range from adding tapered insulation and crickets to re-setting drains; a coating over a ponding roof fixes nothing.

How much does a roof repair cost in Victoria?

There is no honest flat answer — a failed pipe flashing might be a few hundred dollars; re-doing a torch-on detail or a section of soaked roof costs more. What Denis does promise: he finds the actual entry point first, shows you photos, and gives you a written estimate before any repair work starts. No surprise invoices.

My roof is leaking right now. What should I do?

Contain the water inside (bucket under the drip, move anything valuable), then call Denis at 250-889-5620. In bad weather he can apply temporary waterproofing to stop the damage and come back for the permanent repair when it is safe to work. Note: Denis works solo now — no 24/7 standby fleet — but a leaking roof gets priority.

Can you repair a roof another company installed?

Yes. Denis repairs asphalt shingles, torch-on, TPO, PVC, EPDM, composites, cedar, metal, tile, slate and rubber roofs — including systems he did not install. Finding leaks in other people's details is, frankly, a big part of the trade.

Report a leak

Where does the stain show up, when does it drip, and has anyone ‘fixed’ it already? That history is half the diagnosis.

Prefer to talk? Call 250-889-5620 or email info@waterproofingsystems.ca.

☎ Call Denis — 250-889-5620